Using the Rohde and Schwarz RTH1004 ScopeRider, James talks about oscilloscope bandwidth. In this video, learn what oscilloscope bandwidth is, and what it is not, and see two measurements that help you tell if you are being band-limited by an oscilloscope. The episode was sponsored by Rohde & Schwarz.
Low-temperature solder paste makes it easier to reflow-solder and re-work surface mount circuit boards. MG Chemicals offers a Bismuth-based paste that works great from larger passive components to fine pitched packages, like QFN. In this video, learn what solder paste is, what it means for a paste to be “low temperature,” and some things to watch out for when using it. This episode was sponsored by MG Chemicals.
Arbitrary waveform generators can generate almost any waveshape. In this video, see how the MP750290 from Multicomp Pro performs. Its key specs are 160 MHz, 14-bit 1.25 Gigasample per second digital-to-analog converter, 1 million point memory, and over 150 built-in waveforms. The episode was Sponsored by Multicomp Pro.
Almost everyone uses a digital oscilloscope’s zoom features. However, did you know that 40-year-old analog oscilloscopes can do something similar? Delayed time bases on analog scopes sweep twice so that the user can see a slow and fast sweep. In this video, see where “zoom” came from and how engineers accomplished the same measurement back in the day.
Compare the ideal and measured cut-off frequency for a filter with a handheld LCR meter. Unlike a DMM, these meters apply an AC signal (from 100 Hz to 100 kHz) to determine the reactive component of an inductor, capacitor, or resistor. A simple example here is a low-pass filter. See how the ideal and measured cut-off frequency varies. And THEN, see how it compares between a PCB and a Breadboard. This episode was sponsored by…