Blog

DIY Solder-In Oscilloscope Probes | Workbench Wednesdays #50

When you cannot get an oscilloscope probe into a tight spot, can you just use a piece of wire? Sometimes. When signal integrity matters, you CAN use a low-cost DIY solder-in probe. These probes attenuate the signal and use an oscilloscope’s high-bandwidth 50-ohm input. James shows how to build some solder-in probes when they work and when they do not work in this video.

Special thanks to Shabaz on the element14 community for the guide used here.

Fan of making things beep, blink and fly. Created AddOhms. Writer for Hackster.io News. Freelance electronics content creator for hire! KN6FGY and, of course, bald.

Write A Comment

This site uses Akismet to reduce spam. Learn how your comment data is processed.