When you cannot get an oscilloscope probe into a tight spot, can you just use a piece of wire? Sometimes. When signal integrity matters, you CAN use a low-cost DIY solder-in probe. These probes attenuate the signal and use an oscilloscope’s high-bandwidth 50-ohm input. James shows how to build some solder-in probes when they work and when they do not work in this video.
Special thanks to Shabaz on the element14 community for the guide used here.
Vector network analyzers (VNAs) measure how a “network” of components changes the amplitude and phase of signals. By measuring across a wide frequency range, VNAs can create S-Parameters that fully describe the behavior of a circuit. This video uses a PicoVNA 106 to show the basics of what a VNA measures, how they work, and a brief overview of how to use one.
I made a mistake on the explainer graphic for S-parameters. The annoying thing is that I think it was a really good explanation!
Analog Discovery Pro from Digilent comes in a 2-channel (ADP3250) or 4-channel (ADP3450) version. These all-in-one instruments work with a PC over USB or can run entirely standalone.
On the PC the excellent Waveforms software provides virtual instruments like an Oscilloscope, Logic Analyzer, Power Supply, Spectrum Analyzer, Curve Tracer, Network Analyzer, and Impedance Analyzer. Just to name a few. See what this new instrument offers in this hands-on review.
This episode was sponsored by Digilent.
Using the Rohde and Schwarz RTH1004 ScopeRider, James talks about oscilloscope bandwidth. In this video, learn what oscilloscope bandwidth is, and what it is not, and see two measurements that help you tell if you are being band-limited by an oscilloscope.
The episode was sponsored by Rohde & Schwarz.
Low-temperature solder paste makes it easier to reflow-solder and re-work surface mount circuit boards. MG Chemicals offers a Bismuth-based paste that works great from larger passive components to fine pitched packages, like QFN. In this video, learn what solder paste is, what it means for a paste to be “low temperature,” and some things to watch out for when using it.
This episode was sponsored by MG Chemicals.
