Tag

Breadboard

Browsing

Compare the ideal and measured cut-off frequency for a filter with a handheld LCR meter. Unlike a DMM, these meters apply an AC signal (from 100 Hz to 100 kHz) to determine the reactive component of an inductor, capacitor, or resistor. A simple example here is a low-pass filter. See how the ideal and measured cut-off frequency varies. And THEN, see how it compares between a PCB and a Breadboard.

This episode was sponsored by Multicomp Pro

Soldering every circuit you build probably isn’t practical.  At some point you are probably going to want to use some type of temporary method to connect different components together.  One of the popular methods is using a breadboard.  This simple (and cool) looking device only needs a few instructions before you can begin