Tag

WiFi

Browsing

Arduino announced several new products at the 2018 Bay Area Maker Faire. One of those products is the Uno WiFi Rev 2. (Check out this post for an introduction to the MKR Vidor 4000, an FPGA-based board. You can read their official announcement here. This new Uno board represents a significant upgrade for the 8-bit family of Arduino boards. However, I do have a few reservations.

Arduino Uno WiFi Rev 2

Starting off, I am not happy with the name. It is too long. For that reason, I am going to keep using the full name in this post to demonstrate why I don’t like it. Another reason I’m grumpy it that new microprocessor makes it incompatible with 328p code. That said,  sketches (and libraries) using only the Arduino library will (likely) work fine. Anything that uses registers, like direct port manipulation, will have issues. Just like moving to any other architecture supported by the IDE. However, because it has the name “Uno,” many users will be tripped up by incompatibilities. 

Keeping the name “Uno” was only there for marketing reasons. The form factor is the traditional Arduino Uno style. Which begs the question, can we retire that massive USB connector yet? 

Your IoT project needs one of these wireless modules

Getting your project connected to the internet is relatively easy these days. Here are five off the shelf modules that will easily add wireless to your project.

Back when I was in school, I remember spending an entire semester making a RF amplifier board. In fact, I had to use a pencil eraser to remove oxidation on the copper traces to remove an unwanted oscillation, caused by the impedance mismatch of the oxidation on the copper traces. Talk about tough.

These days, adding WiFi or Bluetooth is as simple as adding one of the wireless modules available. Or if you are using an Arduino, skip the modules and just add a shield.

Keep reading for 5 different wireless modules to consider for your project.